Air conditioning system for e.g. sports boats, 12000 BTU
Heating and cooling
For rooms up to 20 square meters
The difference to a normal above-ground air-conditioning system that draws the air out of the room and thus keeps warm air flowing in, is that
the heat in these air conditioners is dissipated into the sea water,
or withdrawn from the sea water during heating and released into the room.
The device works in the cooling process up to a sea water temperature of 32 degrees C. When heated, this little muscle man still draws from the sea water
up to 4 degrees C the heat and releases it to the room. Of course through the
Heat pump effect increased several times.
Every boat owner knows the problems in summer when the eighth or
The sleeping cabin has heated up to 30 degrees and you cannot sleep.
But this small system also creates pleasant temperatures during the day.
The device has a remote control and a display to be attached to the wall.
Technical data can be found in the pictures.
The assembly is relatively easy.
If the system is only to be operated when the engine is switched off, the engine cooling line can be taken for suction.
The sea water is drawn in by a sep.pump,
flows through the air conditioning system, removes heat and flows back into the sea or canal. Thanks to the corrosion-resistant materials, the system can also be used in sea water.
Marine air conditioning 12000 BTU
Scope of delivery:
Air conditioning ready for operation 230 V AC filled with R141 A
Power consumption cooling 0.95 KW, heating 1.1 KW
without mounting material and without sea water pump
There is a display with a cable connection to the
Reading and setting the setpoints (temperature),
as well as a radio remote control
for reading and setting the setpoints (temperature)
There is also a transition piece for the air outlet
from angular to round 125 mm diameter available.
It can be installed above the water level.
For safety reasons, the assembly should not be in the engine compartment
for petrol or gas engines
Connections:
Sea water inlet 19 mm, sea water outlet 19 mm, drain of the condensate tray 16 mm
Supply voltage 230 V ~ AC, 10 A
Additionally required:
1 seawater pump 230 V (connection in the switch box of the air conditioning system)
Assembly should be below the water level
1 seawater connection with pre-filter on the boat
1 seawater outlet on the boat (should be above the water level)
Connection hoses and hose clamps
Pipe insulation for seawater hose
Possibly Pipe clamps
Hose for air transport of the cooled air d 125 mm
The air intake should come from the same room that is to be cooled.
Supply cable 3 x 1.5 mm for 230 V fuse 10A
You can find these parts here in our shop
